Replacing The System Outer Foil And The Inner Blades - Panasonic LAMDASH ES-TLVFE Operating Instructions Manual

Cleaning the Shaver
Cleaning the shaver with water
Apply one
drop of oil to
each of the
system outer
foils
Important
●
When shaking the shaver to remove water, be careful not to hit the main body on the
sink or any other objects. (Failure to do so may cause malfunction.)
●
Do not wipe with thinners, benzine, alcohol etc.
(Doing so may cause malfunction, or cracking or discoloration of the parts.)
→Wipe with diluted soapy water.
●
Do not use cleaning agents other than hand soap or cleaning solution (sold
separately). (Failure to do so may cause malfunction.)
EN15
continued
continued
3
Remove the outer foil section
and
[P. EN16]
rinse under running
water
●
Splashing is reduced by rinsing
the shaver in sonic vibration
cleaning mode.
●
After rinsing with water, shake
the shaver up and down for a few
times to remove excess moisture
and then wipe off any drops of
water with a dry cloth.
4
Dry the shaver.
●
Allow the shaver to dry in the
shade.
●
Remove the outer foil section to
dry the shaver more quickly.
5
Apply oil.
( It will keep the movement of the
blade smooth and maintain a
comfort shave.)
① Apply oil to the system outer
foil and the trimmer.
② Press
, wait for about
5 seconds, and then press
to stop the shaver.
●
Wipe off any excess oil from
the system outer foil.
Cleaning with the brush
Remove the outer foil section and the inner blades
use the brush to remove any beard trimmings.
●
Do not use any brush other than the one provided.
■ Cleaning with the long brush
(Outer foil section, system outer foil, shaver body, trimmer)
Important
●
If you do not clean the parts marked
with , they may clog with beard
trimmings and abnormal noise may
occur. In this case, clean with water
and the brush.

Replacing the System Outer Foil and the Inner Blades

To maintain a comfortable shave, we recommend replacing the system outer
foil every 1 year, and inner blades every 2 years.
Do not throw away the foil frame.
Removing and attaching the blades
Outer foil section
Removing
Press the
left and right
buttons
Push evenly on the right and left
Attaching
(Until it clicks)
* When removing the system outer foil, do not press the buttons with excessive force.
( Doing so may bend the system outer foil, preventing complete attachment to the foil
frame.)
, and
[as described below]
■ Cleaning with the short brush
(Inner blades)
Move the
brush
parallel to
the blades
( Perpendicular motion might dull
the blades or damage the brush)
Clean here!!
We recommend
cleaning the shaver
after each use.
System outer foil Inner blades
Align with
the orientation
of the mark
Press the
Hold the side
left and right
of inner blade and
buttons*
then remove/attach
it one by one
Push firmly
(Until it clicks)
EN16