How To Use - Panasonic LAMDASH ES-TLVFE Operating Instructions Manual

Ac/rechargeable linear shaver
Table of Contents

Advertisement

Available languages
  • EN

Available languages

How to Use

Shaving the beard
Place your finger
on the finger rest
Tips for better shaving
Apply the whole system
outer foil perpendicularly
against the skin and shave
by slowly gliding the shaver
over the face against the
grain of the beard.
The beard under the chin
and around the throat can be
shaved better by stretching the
skin so the beard will stand.
EN11
After about
1
Press
5 seconds
and shave.
The remaining
battery capacity
The "LAMDASH AI
", which
automatically adjusts the power
depending on the beard thickness,
will operate.
( It will shave with high power on areas
where the beard is heavy, and reduce
the power on areas where the beard
is thin, to reduce burden on the skin.)
When finished,
2
press
.
( Turns off after
Notes
about 5 seconds)
The appliance may not operate in an ambient
temperature lower than approximately 5 °C.
Shaving foam, gel, soap, etc. cannot be used.
The sonic vibration cleaning mode is
activated when the power switch is pressed
for more than 2 seconds while the shaver is
not operating (the switch lock is unlocked).
You cannot shave in this mode.
[P. EN14]
To prevent damage to
the system outer foil
Do not shave with only a
part of the blade.
Locking/unlocking the power switch
■ Locking the power switch
Locking operation
Press
Release
The shaver starts operating.
■ Unlocking the power switch
Unlocking operation
Press and hold
for 2 seconds or more
(Until
turns off)
■ When
blinks and the shaver does not operate
The power switch is locked.
■ When the remaining battery capacity is low
Beep sounds indicate the remaining battery capacity is low when the
power switch is turned off.
You can shave even with the AC adaptor connected.
The battery will drain even using the shaver with
the AC adaptor connected.
If there is no remaining battery capacity, charge the
shaver for at least one minute and then shave.
( Since the movement of the blade weakens and
the shaver may stop.)
Locking is completed
Press and hold
Release
for 2 seconds
or more
(Until
glows)
Glows
The shaver will stop
( Turns off after about
operating.
5 seconds)
Unlocking is completed
turns off
The shaver starts
operating.
Continued to the next page
EN12

Advertisement

Table of Contents
loading

Table of Contents