Page 1
Operating Instructions AC/Rechargeable Shaver (Household) ES-LV50 Model No. English Before operating this unit, please read these instructions completely and save them for future use.
Page 10
Charging the shaver Thank you for choosing a Panasonic shaver • Never use the AC adaptor in the bathroom or ES-LV50. Please read all instructions before use. shower room. • Do not use any power cord or AC adaptor other Important than the AC adaptor (RE7-59).
Storing the shaver Protective cap Appliance socket Outer foil section Lock ring • Store the shaver in a place with low humidity after Foil frame Power switch [0/1] use. System outer foil ...
Charge Reading lamps when charging Charging the shaver After charging is While charging completed Insert the appliance plug into the shaver. Plug in the AC adaptor into a household outlet. The charge status lamp ( ) glows. All the lamps will light up •...
Shave Caution • If you press the power switch for more than 2 Using the shaver seconds, the sonic vibration cleaning mode is Page 14 activated. You cannot shave in this mode. • Do not place your fingers on the power switch while using the shaver.
Clean Reading lamps when using Cleaning the shaver While using 1. Disconnect the power cord from • Approximate amount of battery charge the shaver. is displayed as 20 - 100. 2. Apply some hand soap and some water to the outer foil. 3.
The mark on the left means suitable for Cleaning with the brush cleaning under an open water tap. Clean the inner blades using the short brush by moving it Warning in direction (A). Disconnect the power cord from the shaver before Clean the system outer foil, cleaning it in water to prevent electric shock.
• Always insert the system outer foil Replacement parts System outer foil WES9171 to the foil frame when attaching to for ES-LV50 Inner blades WES9170 the shaver. 4. After turning the foil frame mark ) to the front, securely attach the outer foil section to the shaver until it clicks.
Product name AC/Rechargeable Shaver Remove the built-in rechargeable battery before disposing of the shaver. Please make sure that the Product model ES-LV50 battery is disposed of at an officially designated 100-240V 50-60Hz Rated input location if there is one. Do not dismantle or replace the 180mA battery so that you can use the shaver again.