Local Control Mode; Starting Temperature Control; Modifying The Setpoint; Stopping Temperature Control - PerkinElmer PTP-1 User Manual

Local Control Mode

Starting Temperature Control

NOTE: As previously mentioned, it is good practice to allow the system to reach a stable
temperature before inserting a sample. Once the temperature is stable, this control
can be useful for pre-heating samples before running a cycle.
1. Press or hold FUNC until C-01, C-02, S.SP or Conf is displayed in the Lower display
(STOP status).
2. Use the arrow buttons
displayed in the Lower display.
The Upper display shows the current temperature in the cell changer.
3. Press FUNC.
The temperature control starts. The Lower display shows the set temperature and the
Upper display shows the actual temperature.

Modifying the Setpoint

1. When standard temp control is running press the arrow buttons to change the setpoint.
2. To save the setpoint release the arrow buttons.

Stopping Temperature Control

Hold FUNC until the system 'beeps'.
The system returns to STOP status and maintains this setpoint.
and to scroll through these modes until S.SP is
Operation . 41