Disassembly Of The Bearings Box - OMAC B Series Operation And Maintenance Manual

Rev.4 del 01/2011 O.M.A.C. s.r.l.

5.7.3 DISASSEMBLY OF THE BEARINGS BOX

15
After disassembling the rotor case, drain the
oil and the remove drive key on shaft
16
Remove the gear cover and make a refe-
rence mark on gears in order to respect the right
timing while reassembling
17
Disconnect the retainer keys on lock
washers
18
Unscrew the gear ring nut, inserting a non
metal wedge between gears in order to stop
turning
19
Disassemble the shafts, unscrewing the fl
athead screw, with the lock washer
20
Extract the shafts by the posterior side of
the pump
21
extract the oil retainer and the external rings
of the front bearing
5.7.4 Assembly of the bearing box
23
*BEARING ASSEMBLING PHASE*
Prepare the shafts and the bearings, checking
they are without dents and burrs
24
Drive the inner ring on the driving shaft. Re-
peat the operation on the drived shaft
25
Assemble the rear bearing on the driving
shaft and then on the drived one
26
Drive the external bearing rings on the gear
box, observing the depth on the fi gure (10 mm)
27
Insert the snap rings and the spacers for
the axial setting
28
Assemble the shafts by the rear side of the
pump, respecting the timing previously marked
while reassembling, with the numbers marked
"1" and "2" turned towards the high
29
Fixed the rear bearings with the washers
and the fl athead screws
30
The gear couple is composed by a fi xed gear and an adjustable one. Assemble the fi xed gear, then the adjustable one with untightened screws,
taking care to a fi rst approximate rotor timing
31
Tighten the retainer ring nuts with the corresponding safety washers and set rightly the suited retainer key. In order to avoid turning during operation
insert a wedge in soft material among the gear teeth
32
Assemble the rotor case and rotors as previously described and check the "Clearences" (see par.1.3.4).
If rotor clearances are not included in tolerances as prescribed in chap. 1, disassemble rotors, the rotor case and adjust the spacer according to the
requested dimension
33
Being the wedge inserted among the gears tighten the rotor nuts, taking care of the driving torque (see par.1.3.6)
22
extraxt the spacers and the snap rings
23+24
27
30
Via Giovanni Falcone, 8 42048 Rubiera (RE) - Italy
E-mail:info@omacpompe.com SitoWeb:www.omacpompe.com
15 16
19
18
21
25
28
31
O.M.A.C. s.r.l.
Tel.0522/629371 - 629923 Fax 0522/628980
17
20
22
26
29
32 33
Chap.5 - pag.
9