Fundamental Safety Instructions; General Safety Instructions - Siemens SIMOTICS T-1FW68 Configuration Manual

Fundamental safety instructions

1.1

General safety instructions

Electric shock and danger to life due to other energy sources
Touching live components can result in death or severe injury.
• Only work on electrical devices when you are qualified for this job.
• Always observe the country-specific safety rules.
Generally, the following steps apply when establishing safety:
1. Prepare for disconnection. Notify all those who will be affected by the procedure.
2. Isolate the drive system from the power supply and take measures to prevent it being
3. Wait until the discharge time specified on the warning labels has elapsed.
4. Check that there is no voltage between any of the power connections, and between
5. Check whether the existing auxiliary supply circuits are de-energized.
6. Ensure that the motors cannot move.
7. Identify all other dangerous energy sources, e.g. compressed air, hydraulic systems, or
8. Check that the correct drive system is completely locked.
After you have completed the work, restore the operational readiness in the inverse
sequence.
Electric shock due to connection to an unsuitable power supply
When equipment is connected to an unsuitable power supply, exposed components
may carry a hazardous voltage. Contact with hazardous voltage can result in severe
injury or death.
• Only use power supplies that provide SELV (Safety Extra Low Voltage) or PELV-
1FW68 radial segment motors
Configuration Manual, 08/2021, A5E51132930B AA
WARNING
switched back on again.
any of the power connections and the protective conductor connection.
water. Switch the energy sources to a safe state.
WARNING
(Protective Extra Low Voltage) output voltages for all connections and terminals of
the electronics modules.
1
13