Chapter3. Card Reader - Nautilus Hyosung MX8800 Manual

Chapter3. Card Reader

Chapter3. Card Reader
Code Problem Description
3100100 Send to undefined command.
3100200 Command execution is impossible. Restart the Service Provider
3100400 Command data error.
3101000 Latch sensor is abnormal
3102000 Card has not been read yet or
others errors
3102100 No Start sentinel
3102200 VRC Error
3102300 No End sentinel. Too many data
3102400 LRC Error
3102500 No mag.stripe or No encoded card Please confirm which is problem card or
3102700 SS-ES-LRC card
3103000 Detection of Power failure.
3106000 Abnormal condition was found on
the power-line (Vcc) of ICC(or
SAM).
3106100 The receiving error of ATR.
3106200 The card(SAM) does not accept this
protocol.
3106300 IC card(SAM) communication
error(No answer).
3106400 IC card(SAM) communication
error(Other)
3106500 IC card(SAM) is not activated
3106600 IC card(SAM) returned ATR which is
not supported ISO/IEC7816-3
3106900 IC card(SAM) returned ATR which
does not match EMV 2000 V4.0.
3107000 F-FROM write error
3107100 CRC error of User program code
area of ESU
3107200 EEPROM operation error
3107600 Transmission error between ESU
and ICRW
3109500 ESU is broken-down or
disconnected
3109600 Metallic fraud object is detected.
3109900 Internal error is occurred and Fail to
get error code from DLL
9311200 Fail to connect device or initialize
device
9312300 Fail to close device.
© 2014 Nautilus Hyosung, Inc. All Rights Reserved.
Error Code Manual
Troubleshooting
Restart the Service Provider
Restart the Service Provider
Please confirm inside of cardreader
Restart the Service Provider
Please confirm which is problem card or
cardreader
Please confirm which is problem card or
cardreader
Please confirm which is problem card or
cardreader
Please confirm which is problem card or
cardreader
cardreader
Please confirm which is problem card or
cardreader
Issue the Reset command.
Check to cardreader is running well with
IC Chipcard.
Check to cardreader is running well with
IC Chipcard.
Check to cardreader is running well with
IC Chipcard.
Check to cardreader is running well with
IC Chipcard.
Check to cardreader is running well with
IC Chipcard.
Check to cardreader is running well with
IC Chipcard.
Check to cardreader is running well with
IC Chipcard.
Check to cardreader is running well with
IC Chipcard.
Issue the Reset command.
Check the cardreader and ESU board.
Restart the EPP device.
Check the cardreader and ESU board.
Check the cardreader and ESU board.
Check the cardreader and ESU board.
Restart the Service Provider
Check the device cable and connection.
Check the device cable and connection.
3-1