Chapter1. Barcode Reader - Nautilus Hyosung MX8800 Manual

Chapter1. Barcode Reader

Chapter1. Barcode Reader
Code Problem Description
9708014 Fail to open Serial port.
9708030 Fail to create registry
9708031 Fail to read registry information
9708032 Fail to write registry information 1. Reset the Barcode SP
9708034 Fail to delete registry
information
9708042 Fail to start thread of the
BarCode SP
9708043 Fail to stop thread of the
BarCode SP
9708101 Cannot set to enable state on
the BarCode Reader
9708102 Cannot set to disable state on
the BarCode Reader
9708103 Cannot read a BarCode Data
from BarCode Reader
9708104 Detected a error on the
communication line(RS-232C)
9708105 encountered unexpected
timeout from firmware.
© 2014 Nautilus Hyosung Inc. All Rights Reserved.
Error Code Manual
Troubleshooting
1. Check whether the communication
cable and serial port are connected or
not.
2. Change Unit if error is continuous
1. Reset the Barcode SP
1. Reset the Barcode SP
1. Reset the Barcode SP
1. Reset the Barcode SP
1. Reset the Barcode SP
1. Check a barcode reader
2. Check a status of the communication
line
3. Reset the BarCode SP
4. Change Unit if error is continuous
1. Check a barcode reader
2. Check a status of the communication
line
3. Reset the BarCode SP
4. Change Unit if error is continuous
1. Check a barcode reader and barcode
image
2. Check a status of the communication
line
3. Reset the BarCode SP
4. Change Unit if error is continuous
1. Check a barcode reader
2. Check a status of the communication
line
3. Reset the BarCode SP
4. Change Unit if error is continuous
1 .SP Close and Open(Take the Log for
failure)
2. Restart the system
1-1