Table of Contents
Advertisement
HOW TO REPLACE THE BATTERIES
Each handle (A) can use two AAA batteries; alkaline
batteries are recommended. Do not use old and new
batteries together or alkaline, standard, and recharge-
able batteries together. IMPORTANT: If a handle has
been exposed to cold temperatures, allow it to warm
to room temperature before you insert batteries.
Otherwise, you may damage the electronic compo-
nents. Make sure to clean the contacts on the batteries
and the contacts in the battery holders (B) each time you
install batteries.
Locate the battery holder (B) on a handle (A). Remove the
two small screws (C), and then remove the battery holder.
Remove the cover (D), remove the two old batteries if
necessary, and insert two new AAA batteries into the bat-
tery holder (A). Make sure that the negative end of each
battery is pressed against a spring. Then, reattach the
cover, insert the battery holder into the handle (A), and attach it with the two small screws (C). Repeat this step
for the other handle (A).
Note: If the handles (A) will not be used for an extended period of time, remove the batteries from the handles.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this equipment.
IMPORTANT: To satisfy exposure compliance requirements, the antenna and transmitter in the base must
be at least 8 in. (20 cm) from all persons and must not be near or connected to any other antenna or trans-
mitter; the antennas and transmitters in the handles must be at least 1.5 in. (4 cm) from all persons and
must not be near or connected to any other antenna or transmitter.
Note: The adjustable dumbbells contain FCC ID: OMCSBACCEL and FCC ID: 2AC7Z-WROOM32SE.
14
C
B
D
A
A
Hide quick links:
Advertisement
Table of Contents
