Finishing The Setup; Operation - Toro 08754 Operator's Manual

Finishing the Setup

Before operating the finish grader, review the following
materials and save them in an appropriate place:
•
Parts Catalog
•
Installation Instructions

Operation

Operating the Finish Grader
•
Raise or lower the finish grader to control the
grading or scarifying depth.
•
When grading, rotate the scarifier to the upper
position and secure each end with a clevis pin and
hairpin (Figure 5).
1. Scarifier
2. Clevis pin
3. Grading position (upper)
•
When scarifying, rotate the scarifier to the lower
position and secure each end with a clevis pin and
hairpin (Figure 5).
•
The scarifier aggressiveness can be changed
by adjusted the length of the springs
Lengthening the springs will make the scarifier
less aggressive. Shortening the springs will make
the scarifier more aggressive
•
For final grading/leveling, an Adjustable Orifice Kit
(Part No. 112-1433) can be obtained to regulate
the raise/lower speeds.
4
Figure 5
4. Hairpin
5. Scarifying position (lower)
(Figure
g348148
8).