Maintenance - Toro 08754 Operator's Manual

Maintenance

Greasing the Attachment
Adapter
If the locking lever on the attachment adapter does
not pivot freely and easily, apply a light coat of grease
to the area shown in Figure
Adjusting the Actuating
Rod Springs
The springs and actuating rods are adjusted at the
factory. However, if new parts are installed or the
springs are removed for any reason, the spring length
should be adjusted to 5.24 inches (133 mm) as shown
in Figure 8.
7.
Figure 7
Leveling the Finish Grader
g003731
Blade
To level the blade in relation to the traction unit,
place the unit on a level surface (such as a concrete
driveway), and slightly vary the rear tire pressure as
required.
Reversing the Scraper
Blade
The scraper blade
second wear surface after the original edge has worn
beyond the lower edge of the finish grader box that it
is attached to.
6
Figure 8
(Figure 9) can be reversed for a
Figure 9
g003653
g003654