Table of Contents
Advertisement
2
Adjusting the Link
Assembly
No Parts Required
Procedure
1.
With the attachment mounted and secured on
the traction unit, raise the attachment.
2.
Measure the gap between the top washer
and the spacer in the link assembly on the
attachment adapter as shown in
Important:
The gap between the washer and
the shoulder should be 0.060 to 0.080 inches
(1.5 to 2.0 mm).
1. Adjustment nut
2. Jam nut
Figure
Figure 4
3. 0.060 to 0.080 inch (1.5 to
2.0 mm) clearance
3
Finishing the Setup
No Parts Required
Procedure
Before operating the finish grader, review the following
materials and save them in an appropriate place:
•
Parts Catalog
•
Installation Instructions
4.
g353403
3
Advertisement
Table of Contents
