Toro 08754 Operator's Manual page 5

Inspecting and Cleaning
the Finish Grader
When the grading operation is completed, clean the
machine thoroughly. Since this machine is used
primarily in extremely abrasive conditions, the material
should be flushed off after each use. If the machine is
cleaned frequently, it can be cleaned with a stream of
water from a hose with the nozzle removed.
Important:
Do not use pressurized water to clean
the machine; a high pressure stream could drive
sand or other material into wear areas where it
could act as a grinding compound.
Note:
If the attachment adapter becomes stuck to
the traction unit adapter, insert a prybar/screwdriver
into the pry slot to disengage the parts.
g003783
Figure 6
1. Pry slot
5