Replacing A Transceiver Module - HP A-F1000-E Installation Manual

Figure 33 Press the eject button to eject the CF card
Install a new CF card. For more information, see the chapter
Step4
CAUTION:
• To avoid hardware damage, do not remove the CF card when the firewall is booting or the CF card LED
is blinking.
To protect the CF card, place it into an antistatic bag.
•

Replacing a transceiver module

NOTE:
When replacing a transceiver module, make sure that the two transceiver modules connected by the same
optical fiber have the same wavelength.
WARNING!
Do not stare into the optical fibers.
•
• When removing a transceiver module, do not touch the golden finger of the transceiver module.
Follow these steps to replace a transceiver module:
Remove the optical fibers from the transceiver module.
Step1
Pivot the clasp downward to the horizontal position.
Step2
As shown in
Step3
out.
Insert the dust cap to the removed transceiver module, and put the module into its original shipping
Step4
materials.
Install a new transceiver module. For more information, see the chapter
Step5
Figure 34, holding the handle of the transceiver module, gently pull the transceiver module
"Installing the
41
firewall."
"Installing the firewall."