Use the Telnet command to log in to the firewall.
Step4
Logging to the firewall through a web browser
The A-F1000-E supports web-based network management, which allows you to manage and maintain
the firewall in a more user-friendly way.
Your A-F1000-E firewall was delivered with the default web logging information. You can use this default
information to log in to the web page of your firewall. The default web logging information includes:
User name: admin
•
Password: admin
•
•
IP address: 192.168.0.1/24
Follow these steps to log in to your firewall through a web browser:
Connect a cable to the A-F1000-E.
Step1
Connect the Ethernet interface GigabitEthernet 0/0 of the A-F1000-E to a PC by using a network cable.
Configure an IP address for the PC, ensuring the PC and the A-F1000-E can ping each other.
Step2
Set the IP address to any one but 192.168.0.1 within the range of 192.168.0.0/24. For example, set the
address to 192.168.0.2.
Launch the web browser and input the login information.
Step3
Launch the web browser on the PC. Type 192.168.0.1 in the address bar and press Enter. The login dialog
box appears, as shown in
verify code and click Login.
Figure 24 Web login dialog box
Then, the web interface of the A-F1000-E firewall appears.
Performing basic settings for the firewall
This section describes the fast configuration by using the basic configuration wizard. For more
information about how to configure the protocols and features for the A-F1000-E firewall, see the
configuration guides for the firewall.
NOTE:
The web interfaces may vary by the software version.
Figure
24. In this dialog box, enter your user name (admin), password (admin),
24