Accessories Supplied By The Firewall; Checklist Before Installation - HP A-F1000-E Installation Manual

NOTE:
No installation tool or ESD-preventive wrist strap is provided with the firewall. Prepare them yourself.

Accessories supplied by the firewall

Console cable

Checklist before installation

Table 6 Checklist before installation
Item
Installation site
Grounding cable
Requirements
•
Ventilation
•
Operating
0°C to 45°C (32°F to 113°F)
temperature
Operating
10% to 95%
humidity
Cleanness Dust concentration ≤ 3 × 10
•
•
•
•
ESD prevention
•
•
•
•
EMI prevention
•
•
Rear mounting Front mounting
bracket and bracket and M4
load-bearing screw screws
There is a minimum clearance of 10 cm (3.9 in) around
the inlet and exhaust vents for heat dissipation of the
firewall chassis.
A ventilation system is available at the installation site.
The equipment and floor are well grounded.
The equipment room is dust-proof.
The humidity and temperature are at a proper level,
respectively.
Wear an ESD-preventive wrist strap and uniform when
touching a circuit board.
Place the removed CF card or interface module on an
antistatic workbench, with the face upward, or put it
into an antistatic bag.
Touch only the edges, instead of electronic components
when observing or moving a removed CF card or
interface module.
Take effective measures to protect the power system
from the power grid system.
Separate the protection ground of the firewall from the
grounding device or lightning protection grounding
device as far as possible.
Keep the firewall far away from radio stations, radar
and high-frequency devices working in high current.
Use electromagnetic shielding when necessary.
8
Rubber pads
4 particles/m 3
Result