Configuring The Ip Address For An Interface - HP A-F1000-E Installation Manual

Item
HTTPS

Configuring the IP address for an interface

Click Next on the service management configuration page to enter the interface IP address configuration
page, as shown in
Ethernet interfaces and VLAN interfaces. You can click a value in the table and then modify it. Only when
the IP configuration is Static Address, can you configure the IP address and mask.
Figure 28 Basic configuration wizard: 4/6 (interface IP configuration)
Description
Specify whether to enable HTTPS on the device, and set the HTTPS port number.
HTTPS is the HTTP protocol that supports the Secure Sockets Layer (SSL) protocol. It
can improve device security.
Disabled by default.
IMPORTANT:
If the current user logged in to the web interface through HTTPS, disabling
•
HTTPS or modifying the HTTPS port number will result in disconnection with
the device; therefore, perform the operation with caution.
• When you modify a port number, ensure that the port number is not used by
another service.
By default, HTTPS uses the PKI domain default. If this PKI domain does not
•
exist, the system will prompt you for it when the configuration wizard is
completed; however, this will not affect the execution of other configurations.
Figure 28. The table lists the IP address configuration information for all Layer 3
28