Install Software - OnRobot GECKO GRIPPER Quick Start Manual

Hide thumbs Also See for GECKO GRIPPER:
Table of Contents

Advertisement

3. Install Software

NOTE: The Training Mode Screen will appear when connection to the Gripper is
successfully established.
V 1.0
Copyright © 2018 by OnRobot A/S. All rights reserved
3.1.
Install the Windows Desktop GUI from the
OnRobot USB flash drive.
3.2.
Select "Launch Gecko Desktop GUI" checkbox
when installation completes.
3.3.
Configure IP addresses. The default gripper
IP address is 192.168.0.170 Set the computer IP
address: 192.168.0.XXX where XXX is a different
integer between 0-250.
Page 2 of 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GECKO GRIPPER and is the answer not in the manual?

Table of Contents