Korg sampler Basic Manual page 104

In the Sequencer P0: Play/REC, Preference page, the
"Multi REC" check box will be checked.
If you are using the arpeggiator, press the ARPEGGIA-
TOR [ON/OFF] key to turn it off, and then turn it on
again.
3 Begin recording.
Press the [LOCATE] key to set the location to
001:01.000.
Press the SEQUENCER [REC/WRITE] key, and then
press the SEQUENCER [START/STOP] key.
If you play a B3 note or lower during the pre-count
before recording, the arpeggio pattern will start from
the beginning at the moment that recording begins.
Record your performance.
4 When you are finished performing, press the
SEQUENCER [START/STOP] key.
If you made a mistake or want to re-record, you can
use the Compare function (press the [COMPARE] key)
to re-record as many times as you want. (The "Multi-
REC" check box will be unchecked when you use
Compare, so you will need to check it again.)
96
If the recorded performance is not reproduced cor-
rectly during playback
If you use the page menu command "Copy From Combi"
to copy the settings of a combination, and then perform
multi-track recording with the arpeggiator turned on,
there may be cases in which the performance during
recording is not reproduced correctly during playback.
Multiple tracks that are set to the same MIDI channel are
combined into a single stream of performance data during
recording. If there is a track with the same MIDI channel
as the track being played by the arpeggiator, the data
played by the arpeggiator will be combined with the per-
formance data that was played manually, and all of this
data will be sounded by each track of the same channel (if
"Status" is INT).
In such cases, you can solve the problem by changing the
MIDI channel of the track that is played by the arpeggiator,
and then creating a track that will drive the arpeggiator.
If the recorded performance is not reproduced by the
playback, check the following conditions.
These settings can be executed automatically if you
check "Auto adjust Arp setting for Multi REC" in the
page menu command "Copy From Combi." Nor-
mally, you will check this to execute the settings. In
this case, these adjustments will not be necessary, but
you can verify here that the automatic adjustments
have been made.
• Sequencer P7: Arpeggiator, Setup T01–08 page
"Arpeggiator Run" A, B, and "Arpeggiator Assign"
settings
• Sequencer P2: Trk Param, MIDI Ch T01–08 page
"MIDI Channel" settings
If "Arpeggiator Run" A and B are checked, and the
arpeggiator is assigned to a track, make sure that
"MIDI Channel" is set to other than 01.
Make sure that the global MIDI channel (Global P1:
MIDI, "MIDI Channel") is set to 01.
Arpeggiator Run MIDI Channel
If either "A" or "B" 01 only
are checked
01 02, 01 03, etc. No correction required
If both "A" and "B" 01 only
are checked
01 02, 01 03, etc. Correction required for
01 02 03, etc.
*1
Correction
Correction required
Correction required
only one
No correction required/
*2
Correction required