Skope SC112N-A User Manual

Skope SC112N-A User Manual

Four glass sided chiller
Hide thumbs Also See for SC112N-A:

Advertisement

Quick Links

SC112N-A
Four Glass Sided Chiller
Type: HSC112N

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SC112N-A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Skope SC112N-A

  • Page 1 SC112N-A Four Glass Sided Chiller Type: HSC112N...
  • Page 2 E-mail: skope@skope.com Website: www.skope.com Trademark Infringement The SKOPE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after its state, condition, get-up or packaging has been altered in any manner •...
  • Page 3: Table Of Contents

    Troubleshooting......... 11 SC112N-A...
  • Page 4: Installation

    SC112N-A 1 Installation Safety First Always observe safety precautions when using any electrical appliance. Read these instructions carefully and retain them for future reference. WARNING • Ensure the appliance is disconnected from the power supply before performing any cleaning or maintenance.
  • Page 5: Positioning The Fridge

    SC112N-A Positioning the Fridge Climate Class The fridge is designed to operate within a climate class 3 environment (25°C @ 60% RH). Location Select a suitable location for the fridge away from direct sunlight and heat sources e.g. radiators, baseboard heaters, cooking appliances.
  • Page 6: Operation

    SC112N-A 2 Operation Automatic Start-up After the fridge has been positioned in a suitable place, plug it in and check the following activity. Item Activity Condenser fan The condenser fan starts immediately and can be heard. The evaporator fan starts after a few seconds. The...
  • Page 7: Electronic Controller

    SC112N-A Electronic Controller Introduction The electronic controller is visible through a cut-out in the front panel. It uses temperature probes and a door switch to collect data and runs the fridge accordingly. The electronic controller can be manually switched between ‘Normal’...
  • Page 8: Temperature Setpoint

    (all shelves maintain temperatures below 5°C). The cabinet Setpoint setpoint can be adjusted between 0°C and 4°C. SKOPE does not recommend that the setpoint be changed unless it is absolutely necessary, and then only by small increments at a time. To view and adjust the temperature setpoint 1.
  • Page 9: Messages And Alarms

    SC112N-A 2. Press the Up or Down button to scroll the menu until St is shown on the display. 3. Press the Set button. The current setpoint value is shown on the display. 4. Press the Up or Down button to increase or decease the setpoint value to the required temperature.
  • Page 10: Maintenance

    SC112N-A 3 Maintenance Cleaning Many commercially available cleaning products contain solvents that may damage the plastic components of the fridge and cause them to crack. Do not use abrasive or corrosive cleaners or boiling water. CAUTION Isolate the fridge from the power supply before cleaning.
  • Page 11: Troubleshooting

    SC112N-A Troubleshooting For problems with the fridge refer to the following table. Problem Possible Cause Suggestions • Fridge is not • Loss of power supply. • Check mains power supply. operating. • Interior lights are not • Electronic controller • Switch the light on while...
  • Page 12 SKOPE Industries Limited ABN: 73 374 418 306 AU: 1800 121 535 NZ: 0800 947 5673 skope@skope.com www.skope.com...

This manual is also suitable for:

Hsc112n

Table of Contents