Vertical display and storage gen2: single door chiller (62 pages)
Summary of Contents for Skope SC112N-AC
Page 1
SC112N-AC Four Glass Sided Chiller Type: HSC112NA...
Page 2
E-mail: skope@skope.com Website: www.skope.com Trademark Infringement The SKOPE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after its state, condition, get-up or packaging has been altered in any manner •...
SC112N-AC 1 Installation Safety First Always observe safety precautions when using any electrical appliance. Read these instructions carefully and retain them for future reference. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of...
SC112N-AC Positioning the Chiller Climate Class The chiller is designed to operate within a climate class 3 environment (25°C @ 60% relative humidity). Location Select a suitable location for the chiller away from direct sunlight and heat sources, e.g. radiators, baseboard heaters, cooking appliances.
SC112N-AC 2 Operation Automatic Start-up After the chiller has been positioned in a suitable place, plug it in and check the following activity. Item Activity Condenser fan The condenser fan starts immediately and can be heard. The evaporator fan will start after a few seconds. To verify,...
‘Day’ and ‘Night’ modes depending on chiller usage. The electronic controller is pre-programmed and requires no initial setup or additional programming. SKOPE does not recommend that the settings be changed unless it is absolutely necessary.
SC112N-AC Controller The electronic controller will automatically switch the chiller between ‘Day’ and ‘Night’ modes depending on use. If the front door (electronic controller Operation side) is not opened for four hours, the chiller will automatically enter Night mode and the sign and interior lights will switch off. To switch the chiller between Day and Night modes manually, press and hold the Day - Night button on the electronic controller faceplate.
SC112N-AC Messages and Alarms The following table explains messages and alarms that the electronic controller displays. If a warning or alarm persists, contact a service agent. Messages Display Description The chiller is cooling warm product. The chiller is in Day mode and the electronic controller displays the chiller temperature.
SC112N-AC 3 Maintenance Cleaning Many commercially available cleaning products contain solvents that may damage the plastic components of the chiller and cause them to crack. Do not use abrasive or corrosive cleaners or boiling water. CAUTION Isolate the chiller from the power supply before cleaning.
SC112N-AC Troubleshooting For problems with the chiller refer to the following table. Problem Possible Cause Suggestions • Chiller not operating. • Loss of power supply. • Check the mains power supply. • Sign and/or Interior • Electronic controller • Switch the light on while lights not on.
Need help?
Do you have a question about the SC112N-AC and is the answer not in the manual?
Questions and answers