Table of Contents
Advertisement
●Wiring precautions
1) Use the optical fiber cable described in the following manual.
2) There are restrictions on the bending radius of the optical fiber cable.
For details, check the specifications of the cable to be used.
(Example: SC-E5EW series bending radius: 26 mm or more [When fixed part · no loading]
※ For outdoor use excluded)
3) When handling an optical fiber cable, do not touch the optical fiber core of the cable-side or module-
side connector, and protect it from dirt or dust.
If oil from your hand, dirt or dust is attached to the core, it can increase transmission loss, arising a
problem in data link.
4) When connecting or disconnecting an optical fiber cable, hold the connector part of the cable.
If hold the cable part, the cable may break.
5) Make a full connection between the cable-side and module-side connectors until a "click" can be
heard.
6) The self-respect or the tension of the cable must not hang directly in the connector.
It may cause transmission loss or break the cable.
7) Ground (FG grounding) each unit using independent grounding or common grounding.
Use class D grounding (class 3 grounding).
Also, make the distance between the grounding point and this product as close as possible and
shorten the grounding wire.
(Recommended grounding wire thickness: 2 mm
●Installation method
・Installation on DIN rail
1) Hang the upper part of DIN rail attachment on DIN rail.
2) Push the lower part of this product until it sounds "click".
・Removed from DIN rail
1) Pull the body down.(The upper claw has a spring structure)
2) Remove the lower claw from the DIN rail.
◆ Warranty Information
Users are requested to read the following warranty information with care.
Charge-Free Warranty Period and Scope
In the event of a product failure or flaw (hereafter referred to together as "failure") which occurs
during the charge-free warranty period, and which is the responsibility of Mitsubishi, the product
shall be repaired or replaced without charge by way of the outlet where it was purchased, or through
the services of a Mitsubishi regional/branch office. However, in cases where a service person must
be dispatched to a remote area to perform repairs, the customer shall pay the dispatching cost.
■Charge-Free Warranty Period
The charge-free warranty period shall extend for one year from either the date of purchase or delivery (to
specified location). However, because a distribution period of up to six months is possible after the product
has been shipped, the charge-free warranty period shall extend for no longer than 18 months from the
manufacture date. Moreover, the charge-free warranty period for repaired items shall not exceed the
original warranty period (warranty period which applied prior to the repair).
■Charge-Free Warranty Scope
(1) The product's charge-free warranty applies only to cases in which the product has been used in the
manner and in the environment prescribed in the operation manual, with all the conditions and
cautionary items indicated on the product's caution labels having been observed.
(2) The following cases shall be considered as outside the scope of the charge-free warranty, even
if they occur during the warranty period.
1) Product failure caused by the customer (improper storage, handling, carelessness,
negligence, etc.).
2) Product failure resulting from the customer's unauthorized attempts to repair or modify the
product.
3) Product failure caused by using the product in a manner for which it was not intended, or in a
manner which exceeds industry norms.
4) Product failures which could have been prevented had the customer properly maintained or
replaced the cables, accessories, or equipment indicated in the operation manual, etc.
5) Product failure due to a condition which could not have been anticipated within the scope of
technology which existed at the time of shipment from Mitsubishi.
2
or more)
- 6 -
1)
2)
Figure 5.3 Installation method
1)
2)
Figure 5.4 Removed method
click
カチッ
Advertisement
Table of Contents
