Advertisement
Step 6B: Install the Frame Brace assemblies on the adjustable bed frame
Install the four Frame Brace Assemblies on the locations shown on the diagram below.
Repeat Assembly (8 times)
+
Hinge Pin
+
Step 6C: Position the adjustable bed on the bed frame slats
Carefully flip the adjustable bed upright while it is on the floor. Carry the adjustable bed and position it on top of your
existing bed frame slats.
Step 6D: Prepare for movement
Complete 'Step 7: Connect the system to a power source' and 'Step 8: Setup the Wireless Remote' Steps 8 and 9, then
resume with the following step. This will allow operation of the adjustable bed which is necessary for mounting
determining clearances required for installation.
Step 6E: Adjust position on bed frame slats
Use the Wireless Remote up/down adjustment buttons to slowly operate the adjustable bed through its entire range of
motion while monitoring for any obstructions. Reposition the adjustable bed on the bed frame slats as necessary if there
are any obstructions.
Once the ideal position is found command the adjustable bed to the most upright position, to allow easier access to the
Bed Slat Brackets for the following steps.
+
Insert through
Fixed Seat and
Adjustable Bed
Bushing
+
Bushing
Frame
R-Clip
P a g e | 11
Advertisement
