Names And Functions Of Parts; Main Unit - Kenwood VR-905 Instruction Manual

Names and functions of parts

Main Unit

Speaker indicator
CLIP indicator
MUTE indicator
LOUDNESS indicator
TONE indicator
TUNED indicator
ST. indicator
Input channel indicators
*
The Input channel indicators light
up to indicate the channels con-
tained in the input signal. The "S"
indicator lights when the surround
component consists of a single
channel.
POWER
STANDBY STANDBY
ON/STANDBY
ON/STANDBY
SPEAKERS ON/OFF
POWER
ON OFF
PHONES
For VR-906/
VR-905
1 POWER ON/OFF key
(For KRF-V6090D/KRF-V5090D)
Use to turn the main power ON/OFF.
2 ON/STANDBY
key
(For KRF-V6090D/KRF-V5090D)
Use to switch the power ON/STANDBY when
the POWER is turned ON.
STANDBY indicator
2 POWER ON/STANDBY
key
(For VR-906/VR-905)
Use to turn the power ON/STANDBY.
STANDBY indicator
3 DIMMER key
Use to select the REC MODE.
Use to adjust the brightness of the display.
4 LISTEN MODE key
Use to select the listening mode.
Standby mode
While the standby indicator is lit, a small amount of power is supplied to
the system to back-up the memory. This is called standby mode. Under
the condition, the system can be turned ON by the remote control unit.
6 EN
Frequency display,
Input display,
Preset channel display,
AUTO indicator
Surround mode display
DIMMER LISTEN MODE
ACTIVE EQ DTS DOLBY DIGITAL
ACTIVE EQ INPUT MODE BAND AUTO/MONO MEMORY
5 Surround LED (light-emitting diode)
^
indicators
ACTIVE EQ mode LED indicator
^
Lights when this model is in the ACTIVE EQ
mode.
DTS mode LED indicator
Lights when this model is in the DTS mode.
DOLBY DIGITAL mode LED indicator
^ Lights when this model is in the Dolby Digital
mode.
6 SOUND key
Use to adjust the sound quality and the
) ambience effects.
7 MULTI CONTROL knob
¶ Use to control a variety of settings.
8 INPUT SELECTOR knob
∞
Use to select the input sources.
9 VOLUME CONTROL knob
0 PHONES jack
Use for headphone listening.
AUTO DETECT indicator
DIGITAL indicator
Band indicators
DOLBY DIGITAL
indicator
PRO LOGIC
indicator
Display
MULTI CONTROL INPUT SELECTOR
SOUND
SETUP
)
∞
∞
¶
^
*
(
)
CAUTION
The power in this equipment will not be completely cut off from the AC
wall outlet when the main switch is turned OFF.
DSP MODE
6CH INPUT indicator
indicator
(KRF-V6090D/KRF-
V5090D only)
DTS indicator
DISCRETE 6.1
indicator
MATRIX 6.1
indicator
NEO:6
indicator
VOLUME CONTROL
DOWN UP
MUTE
! SPEAKERS ON/OFF key
Use to turn the speakers ON/OFF.
@ ACTIVE EQ key
Use to select ACTIVE EQ setting.
# INPUT MODE key
Use to switch between full auto, digital and
analog inputs.
$ BAND key
Use to select the broadcast band.
% AUTO/MONO key
Use to change "TAPE" indication to "MD".
Use to select the auto tuning mode.
^ MEMORY key
Use to store radio stations in the preset
memory.
& SETUP key
Use to select the speakers' settings etc.
* MUTE key
Use to temporarily mute the sound.
*
)
8
¡
*
¡
™
^
)