Mobile Preset; Theft Deterrent Faceplate; Adjusting Time - Kenwood KDC-316V Instruction Manual

Mobile Preset

This function allows you to adjust the setting that is recalled
with the System Q, according to types of speakers.
1
Press the SRC button repeatedly to select the standby mode.
"ALL OFF/OFF" is displayed when the standby mode is
selected.
2
Press the Q button to enter the mobile preset plan mode.
Press either the 4 or ¢ button to select the type of
3
speaker. The setting switches as follows.
Off ("SP OFF/ SP-F") / For the OEM speaker ("SP OEM/ SP-O")
/ For 6/6x9 in. speaker ("SP 6/6x9/ SP-6") / For 5/4 in. speaker
("SP 5/4/ SP-5")
4
Press the Q button to end the mobile preset plan mode.
NOTE
When you change the setting of type of speaker, the bass,
middle, and treble tone settings are returned to original levels.
Function of the KDC-416S/KDC-316S/KDC-37MR/KDC-316V/KDC-216S

Theft Deterrent Faceplate

The faceplate of the unit can be detached and taken with you,
helping to deter theft.
Release button
Removing the Faceplate:
Press the release button.
The faceplate is unlocked, allowing you to detach it.
Projections
Grooves
— 11 —
NOTE
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts. For that reason, keep the faceplate
in its special storage case while detached.
• Do not expose the faceplate or its storage case to direct
sunlight or excessive heat or humidity. Also avoid places with
too much dust or the possibility of water splashing.
Reattaching the Faceplate:
1
Align the projections on the unit with the grooves on the
faceplate.
2
Push the faceplate in until it clicks.
The faceplate is locked in place, allowing you to use the unit.
Operation of the KDC-316S/KDC-37MR/KDC-316V/KDC-216S/KDC-116S

Adjusting Time

Adjust the time.
1
When the clock is not displayed, first press the CLK button to
display the clock.
2
Press the ADJ button for at least two seconds to enter the
clock adjustment mode. The clock display will blink.
3
• Adjusting the hours
Press the FM button to advance the hours, or press the AM
button to make the hours go back.
• Adjusting the minutes
Press the ¢ button to advance the minutes, or press the
4 button to make the minutes go back.
4
Press the CLK button to end the clock adjustment mode.
NOTE
For time adjustment with the KDC-416S, refer to the Manual
Time Adjustment page for the menu settings. (page 20)