Connecting Wires To Terminals - Kenwood KDC-316V Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the
wire come out from the tab.
Connect either to the power control
terminal when using the optional
power amplifier, or to the antenna
control terminal in the vehicle.
Ignition key
switch
Car fuse box
(Main fuse)
–
+
Battery
2WARNING
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may cause
a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
Front right output (Red)
(KDC-416S/316S only)
Front left output (White)
(KDC-416S/316S only)
Fuse (10A)
Wiring harness
(Accessory1)
P.CONT
Power control/
Motor antenna control wire
ANT
(Blue/White)
CONT
Ignition wire (Red)
ACC
Battery wire (Yellow)
Car fuse box
Ground wire (Black) · (To car chassis)
FM/AM antenna input
KENWOOD disc changer control input
(KDC-416S/316S/37MR/316V only)
NOTE
To connect the Disc changer,
consult your Disc changer manual.
FRONT • L
FRONT • R
REAR • L
REAR • R
2CAUTION
When only two speakers are being connected to the system, connect the
connectors either to both the front output terminals or to both the rear
output terminals (do not mix front and rear). For example, if you connect
the + connector of the left speaker to a front output terminal, do not
connect the - connector to a rear output terminal.
— 26 —
Rear left output (White)
Rear right output (Red)
–
White/Black
To front left
speaker
+
White
–
Gray/Black
To front right
speaker
+
Gray
–
Green/Black
To rear left
speaker
+
Green
–
Purple/Black
To rear right
+
speaker
Purple