Table of Contents
Advertisement
AXIS C1410 Network Mini Speaker
Additional settings
6. Click Save.
7. Set up the SIP settings the same way as for peer-to-peer. See Set up direct SIP (P2P) on page 7 for more information.
Stop audio with DTMF
This example explains how to:
•
Configure DTMF on a device.
•
Set up an event to stop the audio when a DTMF command is sent to the device.
For more information about setting up rules, visit Get started with rules for events.
For more information about the SIP setting options, see SIP on page 26.
1. Go to System > SIP > SIP settings.
2. Make sure Enable SIP is turned on.
If you need to turn it on, remember to click Save afterwards.
3. Go to SIP accounts.
4. Next to the SIP account, click
5. Under DTMF, click + DTMF sequence.
6.
Under Sequence, enter "1".
7. Under Description, enter "stop audio".
8. Click Save.
9. Go to System > Events > Rules and click + Add a rule.
10. Under Name, enter "DTMF stop audio".
11. Under Condition, select DTMF.
12. Under DTMF Event ID, select stop audio.
13. Under Action, select Stop playing audio clip.
14. Click Save.
Play audio when a camera detects motion
This example explains how to set up the audio device to play an audio clip when an Axis network camera detects motion.
Prerequisites
•
The Axis audio device and Axis network camera are located on the same network.
•
The audio clip stored on the Axis audio device.
•
The motion detection application is configured and running in the camera.
Prepare an audio clip link:
1. Go to the device interface of the speaker, by entering its IP address in a web browser.
2. Go to Audio > Audio clips.
> Edit.
9
Advertisement
Table of Contents
