Kenwood DPX-5010 Instruction Manual page 40

Installation (for HONDA ACURA Car)
You can choose from three installation types to fit your car.
Perform "Assembly" before installation.
Assembly
Fit the projections on both sides of the
Accessories 6 and 7 into the slits on
the Accessory4.
Accessory4
(The application
position of
Accessory5 is at the
bottom panel)
Accessory0
(M5 6 mm)
Accessory0
(M5 6 mm)
Accessory6 (L)
Accessory7 (R)
Installation type 1
1
Use Accessory1 to attach the
unit which was assembled in
Assembly.
Accessory1
(M5
DPX-5010
NOTE
If accessories 6 and 7 hit the inside of the console, preventing
the unit from being attached tightly, snap their end parts off as
shown below.shipped with the unit, as shown above.
2CAUTION
Be careful not to get injured with the new edge.
— 40 —
2
Install the center panel
with the unit in your car.
NOTE
The illustration shows an
6 mm)
example of installation
using a vehicle bracket.
The shape of the bracket
varies with the vehicle to
be installed. Some bracket
requires three screws
(Accessory1) on each side.
Accessory67