Compression Control Level Adjustment; Position Setting; Room Size Setting - Kenwood DPX-5010 Instruction Manual

NOTE
• This adjustment cannot be made when the Sound Field Control
is set to "Bypass".
• The default setting is "STEP 2".
4
Press the DSP button to end the DSP control mode.

Compression Control Level Adjustment

This function can compress the dynamic range of music, so
that low sounds which are covered over by road noise can be
raised.
1
Press the DSP button. "DSP CTRL" is displayed once the DSP
control mode is entered.
The DSP indicator blinks during the DSP control mode.
2
Each time you press the COMPRESSION button, the
compression level switches as follows;
"OFF" "STEP 1" (Compression level is lower)
"STEP 3" (Compression level is higher)
NOTE
The default setting is "OFF".
3
Press the DSP button to end the DSP control mode.

Position Setting

This function can set the DSP effects for various listening
positions.
1
Press the DSP button. "DSP CTRL" is displayed once the DSP
control mode is entered.
The DSP indicator blinks during the DSP control mode.
2
Press the POSITION button.
The position currently set appears in the display.
3
Each time you press the POSITION button, the position
switches as follows;
"ALL"
NOTE
• Be sure to set the balance and fader control to center position.
If their settings are not set to center position, the Position
Setting effect will not be obtained properly.
• The default setting is "ALL".
4
Press the DSP button to end the DSP control mode.

Room Size Setting

This function can set the DSP effects for various room sizes.
1
"STEP 2"
Press the DSP button. "DSP CTRL" is displayed once the DSP
control mode is entered.
The DSP indicator blinks during the DSP control mode.
2
Press the ROOM SIZE button.
The position currently set appears in the display.
3
Each time you press the 4 or ¢ button, the room size
switches as follows;
"Large" (For large vans or RVs, etc.) j "Medium"(For sedans,
etc.) j "Small" (For compact cars, etc.)
NOTE
• This adjustment cannot be made when the Position Setting is
set to "ALL".
• The default setting is "Medium".
4
Press the DSP button to end the DSP control mode.
— 23 —
"Front-Right" "Front-Left" "Front" "Rear"