Connecting The Power Cords - JVC EX-A10 Instructions Manual

Connections (continued)
After connecting the DVD player to the TV, select
the video signal type correctly according to the TV.
1
Slide the remote control
mode selector to DVD.
2
Make sure that playback stops.
(If a disc is being played back,
press 7 to stop playback.)
3
Press SCAN MODE.
• The current video signal type will flash.
4
Press 2, 3 (cursor) to select
the video signal type suitable
for the TV.
• You can select "INTERLACE" or
"PROGRESSIVE". You can obtain better
picture quality in the "PROGRESSIVE"
mode than in the "INTERLACE" mode.
When you select "INTERLACE", the image
is displayed alternating between half of the
scanned lines in the "PROGRESSIVE"
mode and the other half of the scanned
lines. The way of displaying the image is a
conventional video signal type.
• Select "INTERLACE" when a TV only
compatible with interlaced video signals is
connected to the DVD player.
• Select "PROGRESSIVE" when a TV
equipped with a component terminal and
compatible with progressive video signals is
connected to the DVD player. When you
select "PROGRESSIVE", the image is
displayed with all scanned lines at the same
time. The image has a higher resolution
than that in the "INTERLACE" mode.
5
Press ENTER.
• The selected video signal type is displayed
for a short time.
NOTE
• Although the picture may be distorted when you
press ENTER, this is not a malfunction of the
system.
• There are some progressive TVs and high-definition
TVs that are not fully compatible with this system,
resulting in an unnatural picture when playing back
a DVD VIDEO with progressive scanning. In this
case, change the scan mode to
• To check the compatibility of your TV, contact your
local JVC customer service center.
• All JVC-manufactured progressive TVs and high-
definition TVs are fully compatible with this system.
• Even if the power cord of the DVD player is
disconnected from the AC outlet or the power is
interrupted, the video signal type setting is stored.
13
Do not turn on the power until you
complete the connection.
" "
INTERLACE .
For the locations of the remote
control buttons, refer to page 11.
CAUTION
• Do not connect an S-video cord and a
component video cord at the same time.
Otherwise pictures may not be played back
properly.
• Connect the DVD player directly to a TV (or a
monitor) without routing through a video
cassette recorder (VCR). Otherwise picture
distortion may occur during playback.
DVD player
Direct connection
• Connecting the DVD player to a VCR-built-in-TV
may also cause picture distortion during
playback.

Connecting the power cords

Receiver
AC outlet
DVD player
AC outlet
• Connect the power cords after you complete the
other connections.
• The STANDBY lamps on the front panels of the
receiver and the DVD player will light up.
TV (or
monitor)
Receiver
(rear panel)
DVD player
(rear panel)