Preparation; Connections; Standard Setup; Connecting The Antennas - JVC EX-A10 Instructions Manual

Connections

Standard setup

Connecting the antennas

Connecting the AM loop antenna (supplied)
1
Set up the AM loop antenna.
2
Connect the antenna cord.
Receiver
(rear panel)
Connect the ends of the
antenna cord as shown
above.
7
Speaker
White
Black
If insulation covers
the tips of the
antenna cord,
twist and pull off
the insulation.
Do not turn on the power until you complete the connection.
DVD player
Receiver Speaker
3
Turn the AM loop antenna to find the best
position for radio reception.
Place the AM loop antenna as far from the
receiver as possible.
• Do not place the AM loop antenna on a metallic
table or close to a TV, computer, or other electric
appliances. Doing so may affect radio reception.
7 When radio reception with the supplied AM
loop antenna is poor
lectric
E wire: 3 - 5 m (not supplied)
Twist
together
electric
wire and
the AM
Electric
loop
wire
antenna
cord.
AM loop
antenna cord
Receiver
(rear panel)
When positioning the antennas, find the best
position for reception while listening to an actual
radio program (refer to "Listening to radio
broadcasts" (A page 18)).

Preparation

Stretch out the electric
wire horizontally,
preferably in a high
place such as above a
window or outdoors.
Connect the AM loop
antenna cord to the
receiver together with
the electric wire.