Mounting - Panasonic CZ-64ESMC3 Installation Instructions Manual

Mounting

When mounting the bottom case (step 2)
Tighten the screws securely until they reach the bottom case.
(Otherwise, loose screw heads may hit the PCB and cause malfunction when
mounting the top case.)
Do not over-tighten the screws.
(The bottom case may be deformed, resulting in fall of the unit.)
Embed the included switch box into the wall beforehand.
1
Preparation to attach the
controller
Remove the control panel.
Control panel
Remove the connector.
Pull out the connector while pushing the claw.
2
Mount to the switch box.
Insert the controller to the switch
box (supplied) that has been
embedded in the wall.
Mount the bottom case. (with the
power supply part attached) of the
controller to the switch box (with
small screws (supplied))
• Do not allow the connection to be
exposed to the external force of wiring.
3
Connector
Claw
Switch Box
(supplied)
Bottom case (with
the power supply
part attached)
Connect the connector, and attach
the control panel.
Connect the connector.
Connector
Claw
Push in until the claw clicks.
Attach it from above.
Do not allow the
wires to come in
contact with parts
on the PCB.
(Caught wires may
destroy the PCB.)
Push in until a
clicking sound
is heard.
15
(EN)