Advertisement
ard or portable crib. Read and follow the warnings and
on the bottom of the Pack ’N Play. The short time you
s will help you use your Pack ’N Play properly.
follow these warnings and the assembly
s could result in serious injury or death.
length and width, and is less than one inch thick in order
to meet safety standards. Using a thicker or a different
sized mattress may allow a child’s head to get between
mattress and the side of the Pack ’N Play causing
suffocation.
! To help prevent suffocation from entrapment,
USE ONLY THE MATTRESS PROVIDED BY GRACO.
he
Never use additional mattress or padding.
N
! Never use plastic shipping bags or other plastic film as
mattress covers not sold and intended for that purpose.
They can cause suffocation.
! Do not use a water mattress with the Pack ’N Play.
Avoiding Strangulation Hazards
! Strings and cords can cause strangulation. Keep strings
and cords away from child.
! Do not place the Pack ’N Play near a window where
p-
cords from blinds or drapes can strangle a child.
! Do not hang strings on or over the Pack ’N Play.
! Do not place items with a string around a child’s neck,
e
such as hood strings, pacifier cords, etc.
! Do not attach strings to toys.
e
This product is not intended for commercial use.
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR PACK ’N PLAY
for worn parts, torn material or stitching. Replace or
repair the parts as needed. Use only Graco
ment parts.
IF PACK ’N PLAY IS USED AT THE BEACH, you
MUST clean sand off your Pack ’N Play, including the
feet, before packing it into cover. Sand in top rail lock
may damage it.
TO CLEAN PACK ’N PLAY, use only household soap
or detergent and warm water. NO BLEACH.
TO WASH CARRY BAG AND FITTED SHEET
(on certain models), machine wash in lukewarm water
on delicate cycle and drip-dry. NO BLEACH.
lure to follow these warnings and
s could result in serious injury or death.
replace-
®
3
Setting up the Pack ’N Play
but only if you know how.
To Set Up Your Pack ’N Play
Step 1.
Undo the three
VELCRO
®
straps. Fold
straps
VELCRO
®
back onto themselves.
Set mattress aside.
Step 2.
IMPORTANT: Leave center
of floor UP until all four
top rails are latched.
Grasp the bottom of two of
the top rails, and pull up until
you hear a “click.”
Be sure top rails
have become rigid.
If not, pull up again until
they are rigid.
FOR SMOOTH SETUP and takedown, it’s impor-
tant to remember one thing: the center of the
floor must be at least halfway up when locking
OR unlocking rails (see picture below).
Therefore:
! ! When setting up, lock rails
BEFORE lowering center.
! ! When taking down, raise center halfway
BEFORE unlocking rails.
Step 3.
Pull up the other two
sides until they latch.
NOTE: If top rails do
not latch, lift the center
of the floor higher.
Center of floor must be
at least halfway up for
the latches to catch
properly.
Be sure all top rails are
rigid.
Step 4.
Hold one end of the unit
up and push the center
of the floor down.
4
is easy,
®
®
Top rail
Advertisement
