Advertisement
REPLACING THE LINE
1. Press the battery latch button, and
remove the battery pack.
2. Rotate the bump knob on the string head
until the line on the centre of the bump
knob aligns with the arrows on the outer
spool.
3. Use a 2.0 mm diameter line. Cut one
piece of the line, approximately 3.0 m in
length. Insert one end of the line through
the eyelet on the side of the string head,
and push until the line comes out through
the eyelet on the other side. Continue to
push the line through the string head until
the line is even in length on both sides.
4. Ensure that there are equal lengths
of line on either side of the string head
(max. 1.65 m per side). Rotate the bump
knob with the speed winder to wind the
line.
NOTE: The bump knob can also be
rotated by hand.
NOTE: When reloading, the line length
should be maximum of 1.65 m each side.
NOTE: Wind the line until approximately
12 cm remains protruding from the trimmer
head.
12
Operation
1
1
2
3
1
4
1
1.65 m
2.5m
12 cm
2.0 mm
2
12 cm
2
2
3
Hide quick links:
Advertisement
