Table of Contents
Advertisement
Filename [XV48EX_EN_08DVD.fm]
XV48EX_EN_01.book Page 37 Saturday, October 9, 2004 10:34 PM
Sound Effect
Using the Sound Effect function, you can change the sound field.
This function works only for analog audio output.
A
Access the selection menu.
Press SOUND EFFECT during playback.
The current setting appears on the TV screen.
B
Select the Sound Effect mode.
Press SOUND EFFECT repeatedly to select the desired
mode.
Each time you press SOUND EFFECT, the Sound Effect mode
changes as follows:
SOUND EFFECT:1]SOUND EFFECT:2]
SOUND EFFECT:3]OFF](Back to the beginning)
As the value becomes bigger, the Sound Effect works stronger.
The selection menu disappears if no operation is done for
about several seconds.
To deactivate Sound Effect
Press SOUND EFFECT
repeatedly until
the TV screen.
VFP Function
— Adjusting the Picture Quality
The VFP (Video Fine Processor) function enables you to adjust
the picture character according to the type of programming,
picture tone or personal preference.
A
Access the VFP setting menu.
Press DVD PICTURE during
playback.
The current setting appears on
the TV screen.
B
Select the VFP mode.
Press w e repeatedly.
Each time you press w e, the VFP mode changes as follows:
NORMAL]CINEMA]USER 1]USER 2](Back to the
beginning)
NORMAL
:
For watching TV in a general room.
CINEMA
:
For watching a movie software in a room
with suppressed light.
USER 1
/
You can adjust parameters that affect the
USER 2
:
picture appearance and store the settings. Go
C
to step
.
Page 37
To adjust picture appearance manually
C
Press w e repeatedly to select "USER 1" or "USER 2."
D
Press rt repeatedly to select a parameter you want to
adjust, then press ENTER.
Adjust gradually and confirm picture appearance results are as
preferred.
GAMMA
(LOW/MID/
HIGH):
BRIGHTNESS
(–16 to +16):
CONTRAST
(–12 to +12):
SATURATION
(–16 to +16):
TINT
(–16 to +16):
"OFF" appears on
SHARPNESS
(LOW/ HIGH):
Y DELAY
(–2 to +2):
VFP menu disappears and the following pop-up window
appears on the TV screen.
E
Press rt repeatedly to change the setting, then press
NORMAL
ENTER.
+0
GAMMA
+0
BRIGHTNESS
The current VFP settings appear again.
+0
CONTRAST
Repeat steps D and E to adjust other parameters.
+0
SATURATION
+0
TINT
To return to the normal screen
+3
SHARPNESS
+0
Press DVD PICTURE.
Y DELAY
NOTE:
The VFP setting screen disappears if no operation is done for
more than about 10 seconds.
Masterpage:Right-No-Heading
Access the USER menu.
Select the parameter.
Adjust this if the neutral color is bright or dark.
The brightness of dark and bright portions is
maintained.
Adjust this if the picture is bright or dark on
the whole.
Adjust this if the objects in far and near
positions look unnatural.
Adjust this if the picture is whitish or blackish.
Adjust this if the appearance of flesh tone is
unnatural.
Adjust this if the picture is indistinct.
Adjust this if the picture looks separately or
overlapped.
GAMMA
GAMMA
+0
Adjust the parameter.
9 October 2004 10:34 pm
37
EN
+ 0
Advertisement
Table of Contents
