Manual Tracking - JVC HR-XV48E Instructions Manual

Filename [XV48EX_EN_07S-VHS.fm]
XV48EX_EN_01.book Page 20 Saturday, October 9, 2004 10:34 PM
20
EN
Slide to the
right.
Instant ReView
Simply by pressing a single button, the unit power comes on,
rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the unit is off and that the Timer
mode is disengaged.
Activate Instant ReView.
Press . The unit power comes on and the unit
searches for the index code indicating the start of the last
timer-recorded programme. Once it's found, playback
begins automatically.
To watch the first of the 3 programmes, press
times. The unit searches and begins playback automatically.
You can access a programme as far as 9 index codes away
from the current tape position.
Repeat Playback
Your unit can automatically play back the whole tape 100 times
repeatedly.
1
Start playback.
Press 4.
2
Activate Repeat Playback.
Press 4 and hold for over 5 seconds, then release.
The Play indicator ($) on the front display panel blinks slowly.
After playing back a tape 100 times, the unit stops
automatically.
3
Stop Repeat Playback.
Press 8 at any time.
Pressing 4, 3, 5 or 9 also stops Repeat Playback.
Page 20
OPERATIONS ON VHS DECK (cont.)

Manual Tracking

Your unit is equipped with automatic tracking
control. During playback, you can override this
and adjust the tracking manually by pressing the
TRACKING +/– buttons.
1
Override automatic tracking.
During playback, press TRACKING +
at the same time.
2
Adjust the tracking manually.
Press TRACKING +/–.
Press TRACKING + and – at the same time again to return to
automatic tracking.
NOTE:
When a new tape is inserted, the unit enters the automatic
tracking mode automatically.
Soundtrack Selection
Your unit is capable of recording three soundtracks (HI-FI L,
HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing A.MONITOR changes the soundtrack as follows:
Track
On-screen display
HI FI
L j h R
HI FI
L j
HI FI
h R
NORM
HI FI
NORM
NOTES:
"HIFI L j h R" should normally be selected. In this mode,
three
Hi-Fi stereo tapes are played back in stereo, and the normal
audio track is played back automatically for tapes with only
normal audio.
For instructions on recording stereo and bilingual
programmes, refer to page 23.
"O.S.D." must be set to "ON" or the on-screen displays will
not appear. ( pg. 53)
Masterpage:Left+
and –
Use
For Hi-Fi stereo tapes
For main audio of Bilingual tapes
For sub audio of Bilingual tapes
For audio-dubbed tapes
For audio-dubbed tapes
October 9, 2004 10:34 pm