Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Warning Messages
UNLOAD NOT ALLOWED
BB3 SYSTEM ERROR
RC COMMUNICATION ERROR
RCE COMMUNICATION ERROR
JOY 1 COMMUNICATION ERROR
JOY 2 COMMUNICATION ERROR
NO GATE SENSOR
GATE POSITION ZERO
NO GROUND SPEED SIMULATION
UNDER APPLICATION-SPINNER
UNDER APPLICATION-CONVEYOR
UNDER APPLICATION-PREWET
UNDER APPLICATION-ANTI-ICING
OVER APPLICATION-COVEYOR
OVER APPLICATION-PREWET
OVER APPLICATION-ANTI-ICING
CALIB:GND SPD PULSES TOO LOW
SPINNER MAX RPM TOO LOW
CONVEYOR MAX RPM TOO LOW
PREWET MAX HZ TOO LOW
ANTI_ICING MAX HZ TOO LOW
WRONG SPINNER CONTROL MODE
SPARE
WRONG PREWET CONTROL MODE
WRONG ANTI-ICING CONTROL MODE 45
WRONG CROSS-CONVEYOR MODE
WT/REV TOO LOW
WT/REV TOO HIGH
PREWET PULSES/GAL TOO LOW
PREWET PULSES/GAL TOO HIGH
ANTI-ICING PULSES/GAL TOO LOW
#
Suggested Solution
21
Vehicle needs to be stationary
22
Check if RCE present, Reboot
23
Comm failure between display and RC
24
Comm failure between RC and RCE
25
Comm failure between RC and Joystick 1
26
Comm failure between RC and Joystick 2
27
Check gate sensor, cable break
28
Gate closed in READBACK mode
29
Speed Simulation mode stopped
30
Spinner not able to reach desired RPM
31
Rate or speed too high, incorrect calibration
32
Rate or speed too high, incorrect calibration
33
Rate or speed too high, incorrect calibration
34
Min null or gate too high,
35
Min null too high, rate too low
36
Min null too high, rate too low
37
Too few or no pulses, recalibrate
38
Bad or no sensor
39
Bad or no sensor
40
Too few pulses, or sensor failed
41
Too few pulses, or sensor failed
42
Auto null not allowed for MANUAL mode
43
Not used
44
Auto-null or volume calibration not allowed
Check Anti-icing or Cross-Conv modes
46
Check Cross-Conv mode setting
47
Check conveyor sensor, and calibrate again
48
Check conveyor sensor, and calibrate again
49
Check prewet sensor, and calibrate again
50
Check prewet sensor, and calibrate again
51
Check anti-icing sensor, and calibrate again
Bosch Rexroth Canada ı 07.22.2013 ı Revision 2.0
16/18
Advertisement
Table of Contents
