Yamaha EF7200DE Owner's Manual page 22

h
j
h
g
j
k
l
12. Install the washers into wheel axle.
13. Insert cotter pins into wheel axle frame, and then
g
j
g Wheel
h Washer
j Cotter pin
14. Fasten the wheel axle frame to the generator
k
k Bolt (8 × 16 mm Flange bolt)
;
l Wheel axle frame
;
; Nut (8 mm Flange nut)
TIP
Refer to the illustration and confirm the position of the
wheel kit.
bend as shown in the illustration.
frame with the bolts and nuts. Make sure that the
wheel axle frame is on the right side of the control
panel.
Tightening torque:
16 N·m (1.6 kgf·m, 12 lb·ft)
– 17 –