Sleep Operation - Jensen JiMS-182 Owner's Manual

Stopping the Alarm
The alarm is programmed to continuously sound for 60 minutes. To stop the alarm,
follow the directions below.
1. SNOOZE / DIMMER Button – Press this button to stop the alarm temporarily.
The alarm will stop and automatically resume after 9 minutes.
2. POWER/STANDBY Button – Press this Button to stop the alarm which will
sound again 24 hours later.
3. ALM.1 / MEM- or ALM.2 / MEM+ Button – Press this Button once to stop the
alarm and the alarm will sound again 24 hours later.
DIMMER Operation (With AC Adaptor plugged in)
In power off mode, press the SNOOZE / DIMMER Button repeatedly to adjust the
LCD backlight to low, middle or high as desired.
Note:
i. With the AC Adaptor plugged in and with power off, press any button except
SNOOZE/DIMMER and the LCD backlight will automatically set to high and
resume to the preset brightness in approximately 5 seconds.
If using battery power, the LCD backlit is always set to the dimmest
ii.
level in order to conserve battery power. Press any button the LCD
backlight will automatically set to high and resume to the dimmest level
in approximately 5 seconds.
Turning the Lamp On/Off
1. You can press the LIGHT button to turn the Lamp on and off.
2. The Lamp will also light automatically one minute before the alarm time is
reached and increase to the full brightest level when the alarm time is reached.
3. When you stop the alarm by pressing the SNOOZE/DIMMER,
ALM.1/MEM- or ALM.2/MEM+ Button, the Lamp will be turned off at the same
time. You can also press the LIGHT Button to turn off the Lamp directly.
4. If the Lamp is on before waking to alarm, radio or iPod, when you stop the
alarm by pressing the SNOOZE/DIMMER,
or ALM.2/MEM+ Buttons, the Lamp will remain on. To turn the Lamp off press
the LIGHT Button once.
Your JiMS-182 can be programmed to turn off according to your preset sleep time.
The sleep time can be set for 15, 30, 60, 90 or 120 minutes.

SLEEP OPERATION

10
POWER/STANDBY, ALM.1/MEM-
POWER,