Warranty And Liability; Environmental Protection, Disposal - Fein Slugger JHM Magforce X Instruction Manual

Repair and customer service.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself:
Application tools, handles, chip guard, safety
strap
Cooling-lubricant system.
Flush the cooling-lubricant system with
water, clean and drain it completely when
not using the machine for periods longer
than two weeks.
For continuous operation, the cooling-lubri-
cant system must be flushed with water and
cleaned approx. every 4 weeks.
Service.
Have maintenance carried
WARNING
out only through qualified
personnel. Incorrectly mounted cables and
components can cause serious injuries.
Have the required service carried out only
through an authorized Slugger repair facility.
When replacing the power
CAUTION
tool's protective cable bush-
ing or cord between the drill stand and drill
motor is required, this must be carried out
by Slugger or by an authorized Slugger Ser-
vice Agent, in order to avoid hazardous sit-
uations.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.

Warranty and liability.

The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed.

Environmental protection, disposal.

Packaging worn out power tools and accessories should be sorted for environmentally
friendly recycling. Further information can be obtained from your dealer.
Cleaning.
Prior to any cleaning or main-
WARNING
tenance, disconnect the
power tool from the power
supply in order to avoid acci-
dents.
When using in environments
WARNING
with conductive dust in the
air, such as when working metals, this dust
can settle in the interior of the power tool.
This can impair the total insulation of the
power tool. Therefore, regularly blow out the
interior of the power tool from outside via
the ventilation openings with dry, oil-free
compressed air; always wear eye protection
when doing this. For additional protection,
connect a residual current device (RCD) on
the line side.
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon-tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.
en
15