Related Manuals for Leviton DIMENSION 4200
Summary of Contents for Leviton DIMENSION 4200
- Page 1 Installation Guide 4200 A IMENSION RCHITECTURAL IGHTING ONTROLLER Software revision 1.12 and above...
-
Page 2: Table Of Contents
Assigning a Dimmer Circuit Channel Number ......4 Terminating the Wiring ............. 4 Configuring the Dimmer Cabinets..........5 Testing the Stations ..............6 DVANCED ONFIGURATION Setting the Personality .............. 7 Clearing the Memory..............7 ARRANTY NFORMATION Warranty.................. 9 Leviton D4200 Architectural Lighting Controller... -
Page 3: Installation Recommendations
Installation Guide Installation Recommendations For best results using the Dimension 4200 Architectural Lighting Controller, follow these recommendations: • Plan the system before beginning the installation. • Test the wiring. • Terminate all wiring with appropriate connectors. • Verify wiring for shorts and open circuits. -
Page 4: Accessing The Second-Level Setup Menu
Do not proceed if your lighting controller was programmed at the factory. To access the second-level Setup menu: Press and hold the Menu/Cancel button for 10 seconds, until LEVITON appears on the LCD display. Immediately release the Menu/Cancel button. Press and hold the Zone 4 Down button for at least 10 seconds, until LEVITON disappears from the LCD display. -
Page 5: Setting The Network Id
ID is mated to the Network ID.) Press the Select/Save button to save the values. Press the Menu/Cancel button to exit this menu. Exit the second-level Setup menu. Leviton D4200 Architectural Lighting Controller Page 3 of 9... -
Page 7: Configuring The Dimmer Cabinets
Each station should be tested for proper operation before the next station is connected. If a station does not appear to control circuits properly after being configured, resolve the problem before continuing. Leviton D4200 Architectural Lighting Controller Page 5 of 9... -
Page 8: Testing The Stations
Test each station by raising and lowering each zone that is assigned to a dimmer. Check to see that control of the dimmer cabinet or other control device is correct and smooth. Leviton D4200 Architectural Lighting Controller Page 6 of 9... -
Page 9: Advanced Configuration
Immediately release the Menu/Cancel button. Press and hold the Master Down button until the LCD display shows INITIALIZING DEFAULTS. Once LEVITON appears on the LCD display, the memory is reset to the factory default values. Leviton D4200 Architectural Lighting Controller Page 7 of 9... - Page 10 Press the Select/Save button to select the desired submenu. Make the necessary changes. Press the Select/Save button to save the settings. Exit the second-level Setup menu. Leviton D4200 Architectural Lighting Controller Page 8 of 9...
-
Page 11: Warranty Information
Leviton is not responsible for removing or replacing equipment on the job site, and will not honor charges for such work. Leviton will not be responsible for any loss of use time or subsequent damages should any of the equipment fail during the warranty period, but agrees only to repair or replace defective equipment returned to its plant in Tualatin, Oregon.
Need help?
Do you have a question about the DIMENSION 4200 and is the answer not in the manual?
Questions and answers