Table of Contents
Advertisement
Product support
Help is always at hand
Troubleshooting & Tips
TV will not turn on
Make sure the power cord is plugged in securely to a wall
outlet. Press the Power button on the TV.
Poor picture
• Check if you have correctly tuned the TV.
• Low signal level can cause picture distortion. Please
check antenna connections.
• Check if you have entered the correct channel frequency
if you have performed manual tuning.
No picture
• TV is not receiving any signal. Make sure the correct
source has been selected.
• Is the antenna connected properly?
• Is the antenna cable damaged?
• Are suitable plugs used to connect the antenna?
• If you are in doubt, consult your dealer.
No sound
• Check if the TV sound is muted. Press the Mute button
or increase the volume to check.
• Sound is coming from only one speaker. Check the
balance settings from Sound menu.
• Check Sound Output option is set correctly from Sound
menu.
Remote control - no operation
• The batteries may be exhausted. Replace the batteries.
Input sources - can not be selected
• If you cannot select an input source, it is possible that
no device is connected. If not;
• Check the AV cables and connections if you are trying to
switch to the input source dedicated to the connected
device.
The Image is not centred in VGA source
To have your TV automatically centre the image, enter
the PC Position menu in Picture menu highlight
Autoposition and press OK. Wait for it to finish. In order
to set the position of the image manually you can use
H Position and V position options. Select the desired
option and use Left and Right directional buttons on the
remote to set.
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105, a Bush enquiry line.
58
Product support
DVD Troubleshooting
Poor picture quality (DVD)
• Make sure the DVD disc surface is not damaged.
(Scratch, fingerprint etc.)
• Clean the DVD disc and try again.
See instructions described in "Notes on Discs" to clean
your disc properly.
• Ensure that the DVD disc is in the tray with the label
facing forward.
• A damp DVD disc or condensation may effect the
equipment. Wait for 1 to 2 hours in Standby to dry the
equipment.
Disc does not play
• No disc in the machine. Place a disc into the loader.
• Disc incorrectly loaded.
Note: Ensure that the DVD disc is in the tray with the label
facing forward.
• Wrong type of disc. The machine cannot play CD-
ROMS, etc. The region code of the DVD must match
the player.
Wrong OSD language
• Select the language in the set-up menu.
• The language for the sound or subtitles on a DVD cannot
be changed.
• Multilingual sound and/or subtitles not recorded on
the DVD.
• Try to change the sound or subtitles using DVD's title
menu. Some DVD's do not allow the user to change
these settings without using the disc's menu.
• These functions are not available on the DVD.
No picture
• Make sure you have pressed the correct buttons on the
remote control. Try once more.
No sound
• Check if volume is set to an audible level.
• Make sure the sound isn't turned off by mistake.
Distorted sound
• Check that the appropriate listening mode setting is
correct.
If nothing works
If you have tried the above solutions and none seem to
work, try switching your TV-DVD off and on again. If this
does not work, contact your supplier or TV-DVD repair
technician. Never attempt to repair a defective TV-DVD
yourself.
Advertisement
Table of Contents
