Table of Contents
Advertisement
Service Manual
Tap "Temperature" to enter the page "Select temperature parameter". Slide up or down to adjust temperature. Tap "Upper limit" or "Lower
limit".
Tap "Mode" and "On/Off" to select the status of master device. Then tap "Save".
Step 2: Set time parameter for linkage. Tap "Time parameter" to enter the page "Set time". Slide
rightwards to turn on the setting
time.
Tap "Execution time"; then tap "Start" and "Stop" to set start time and stop time respectively. Tap "OK" at the top right corner to save the
setting.
Tap the days below "Repeat" to select the repeating days. Then tap "Save".
Step 3: Select "Execute command" Tap "Execute command" and enter the page "Select device".
Installation and Maintenance
41
Hide quick links:
Advertisement
Table of Contents
