Riello Guliver RG1RKD Installation, Use And Maintenance Instructions page 57

3. INSTALLATION
THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.
3.1 WORKING POSITION
The burner is designed to work only in the positions, 1 and 2.
Installation 1 is preferable, as it is the only one that allows performing maintenance operations as de-
scribed in this manual. Installations 2 allow working operations but not maintenance with hooking to the
boiler. Any other position could compromise the correct working of the appliance.
Installations 3, 4 and 5 are forbidden for safety
1 2
3.2 BOILER FIXING
To install the burner on the boiler, do the following:
Put on the flange (1) the screw and two nuts, (see fig. 3);
Widen, if necessary, the insulating gasket holes (5), (see fig. 4);
Fix the flange (1) to the boiler door (4) using screws (2) and (if necessary) the nuts (3) interposing
the insulating gasket (5), (see fig. 2).
Fig. 2
Fig. 3
3.3 FUEL SUPPLY
1
3361
reasons.
3 4
Fig. 5
2
4
GB
5
D7088
Fig. 4
S7189
The burner is designed to al-
low entry of the oil supply pi-
pes on either side.
Depending on the oil supply
pipes position (to the right or
to the left hand side of the
burner) the fixing plate (1) and
1
cable clamp (2) should be re-
versed, (see fig. 5).
D5701
D5012