Table of Contents
Advertisement
CAUTION: To avoid possible electrical shock, before installing your fan,
disconnect the power by turning off the circuit breakers to the outlet box
and associated wall switch location . If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a
tag, to the service panel .
2-1 . Drill two pilot holes into the wood support structure through the
outermost holes in the outlet box . The pilot holes should be 9/64"
in diameter .
2-2 . Your fan comes with four neoprene noise isolators ("Isolators") .
Position the isolators between the ceiling plate and ceiling by
inserting the raised areas on each isolator into the holes in the
ceiling plate .
2-3 . Thread the lead wires from the outlet box down through the hole
in the middle of the ceiling plate .
2-4 . Align the slotted holes in the ceiling plate with the pilot holes you
drilled in the wood support structure . For proper alignment use
slotted holes directly across from each other .
Note: The isolators should be flush against the ceiling .
2-5 . Place a flat washer on each of the two 3" wood screws and pass
the screws through the slotted holes in the ceiling plate into the
pilot holes you drilled .
Tighten the screws into the 9/64" pilot holes; do not use lubricants
on the screws . Do not over tighten .
Flat Washer
2 • Installing the Ceiling Plate
3" Wood Screw
7
41847-01 • 05/28/10 • Hunter Fan Company
Isolator
Ceiling
Plate
Steps 2-3 – 2-5
For Angled Ceilings: Be sure to
orient the ceiling plate so that the
arrows printed on the ceiling plate are
pointing toward the ceiling peak .
Step 2-2
Advertisement
Table of Contents
