Environment; General Information - Festool CTC SYS I Original Instructions Manual

17 Environment

Do not dispose of the device together with do­
mestic waste! Dispose of machines, accesso­
ries and packaging at an environmentally re­
sponsible recycling centre. Observe the valid
national regulations.
Battery Disposal
WARNING
Risk of fire or injury
► Do not attempt to disassemble the battery
or remove any component projecting from
the battery terminals.
► Prior to disposal, protect exposed termi­
nals with heavy insulating tape to prevent
shorting.

18 General information

18.1 Information about Bluetooth
As soon as the tool is connected to the Festool
Work app via Bluetooth
nection has been authorised, the tool will con­
nect automatically to the Festool Work app
from this point onwards. The tool then regularly
sends status information (ID, operating status,
etc.) via Bluetooth .
®
The Bluetooth ® word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
18.2 Information on data privacy
The tool contains a chip which automatically
stores machine and operating data. The data
saved cannot be traced back directly to an indi­
vidual.
The data can be read using special (contactless)
devices and shall only be used by Festool for
fault diagnosis, repair and warranty processing
and for quality improvement or enhancement of
the power tool. The data shall not be used in
any other way without the express consent of
the customer.
18.3 Federal Communications Commission
(FCC) Interference Statement
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interfer­
ence in a residential installation. This equip­
ment generates, uses and can radiate radio fre­
quency energy and, if not installed and used in
®
® and the secure con­
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interfer­
ence will not occur in a particular installation. If
this equipment does cause harmful interfer­
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equip­
ment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the re­
ceiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
NOTE: Any changes or modifications not ex­
pressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
18.4 Notes (ISED)
This Class B digital apparatus complies with
Canadian ICES-003 and RSS-210. Operation is
subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference, in­
cluding interference that may cause undesired
operation of the device.
18.5 RSS Compliance Statement
This device complies with Industry Canada's li­
cence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, in­
cluding interference that may cause undesired
operation of the device. This device has been
designed and complies with the safety require­
ment for RF exposure in accordance with
RSS-102, issue 5 for portable conditions.
Déclaration de conformité CNR
L'appareil est conforme aux CNR exempts de li­
cence d'Industrie Canada. Son fonctionnement
est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d'inter­
férences, et
(2) cet appareil doit supporter toutes les inter­
férences, y compris celles susceptibles d'en
perturber le fonctionnement. Cet appareil et sa
conception satisfont aux exigences de sécurité
s'appliquant à l'exposition aux RF suivant
English
17