Table of Contents
Advertisement
English
The green LEDs on the status display [1-12] in
dicate the current performance level.
11.2 Connecting sleeve
The bypass function of the connecting sleeve
prevents strong suction from sanding machines
and floor nozzles on smooth surfaces.
Open
► Turn the adjusting ring to the "OPEN" posi
tion.
Close
► Turn the adjusting ring to the "CLOSE" posi
tion.
11.3 Temperature cut-out
To protect against overheating, the tempera
ture cut-out switches off the cordless mobile
dust extractor before it reaches the critical
temperature. The status display LED [1-12] in
dicates a fault.
LED lights up red
► Switch off the cordless mobile dust extrac
tor, let it cool down.
► Switch the cordless mobile dust extractor
on again after approx. ten minutes.
11.4 Connecting with the T-Loc
The cordless mobile dust extractor can be
closed, opened and connected by turning the T-
Loc:
–
Close the cordless mobile dust extrac
tor [3a].
–
Open the cordless mobile dust extrac
tor [3b].
–
Connect the cordless mobile dust extractor
to the storage box [3c].
Before lifting, always close the T-Loc at
the cordless mobile dust extractor or
connect to the storage box and check for secure
holding.
Max. load for connection to other Systainers: 20
kg
11.5 Use/Adjust shoulder strap [4]
Max. permissible load of shoulder strap: 20 kg
The shoulder strap can be attached in two dif
ferent positions:
–
Carrying the cordless mobile dust extrac
tor: Shoulder strap on the cordless mobile
dust extractor [4a]
–
Carrying the storage box with the cordless
mobile dust extractor: Shoulder strap on
the storage box [4b]
14
Excessive temperature
Before lifting, check the shoulder strap for
proper functionality and put the T-loc on the
cordless mobile dust extractor into the corre
sponding position.
Adjust the length of the shoulder strap at the
adjusting tab [4c].
12 Working
12.1 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
► Always use a filter bag!
CAUTION
Hazardous dust
Damage to the respiratory passage
► Check that the main filter is undamaged
before extracting.
When extracting dust that exceeds the
limit value, only extract from one dust
source (power or compressed-air tool).
Observe the following when extracting dust
generated by operating power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: Exhaust air max. 50% of the fresh
air volume
Equation: room volume V
Observe the following information:
–
Keep the area around the exhaust air open
ing [1-8] clear.
–
The cordless mobile dust extractor is a sta
tionary system and not suitable for pulling
at the suction hose. Use the handle [1-4],
front handle [1-7] or shoulder strap [4].
Two cleaning nozzles [5] are stored inside
the storage box.
12.2 After finishing work
► Switch off the cordless mobile dust extrac
tor.
► Remove the battery pack.
Note: Keep the unused battery pack away
from metal objects (e.g. nails, screws, keys,
paper clips, etc.) as these may cause bridg
ing of the contacts.
► Empty the dirt trap.
x air renewal rate L
R
W
Advertisement
Table of Contents
