Installing the Lubrication Controller
AUTOMATIC SYSTEM ACTIVATION HAZARD
Unexpected activation of the system could result in seri-
ous injury, including skin injection and amputation.
This device has an automatic timer that activates the
pump lubrication system when power is connected or
when exiting the programming function. Before you
install or remove the Lubrication Controller from the
system, disconnect and isolate all power supplies and
relieve all pressure.
1. Select a flat surface to install the Lubrication Con-
troller. Drill mounting holes. Refer to Mounting Hole
Layout Provided in the Technical Data section of this
manual, page 16.
2. Remove Lubrication Controller cover and align junc-
tion box with predrilled holes (F
screws (not provided) to secure junction box to
mounting surface.
a
F
. 3
IG
3A2960A
. 3, (a). Use two
IG
a
Installation
5