Functions; Display "No Connection; Connection Search; Signal Strength - Conrad Electronic 75 15 09 Operating Instructions Manual

7. Functions

7.1 Display "no connection"

If the device indicates "no connection", this means that the receiver does not receive
the camera's radio signal.
In this case, perform a connection search.
If the connection search is not successful, the camera may be outside of the range.
Place the camera closer to the receiver.

7.2 Connection search

• Press the button "Menu" (15) on your receiver. This takes you to the setup menu.
• With the buttons "Up" (14), "Left" (16), "Down" (17) or "Right" (20), select the
menu item "Pair CAM".
• Then select the desired channel (1, 2, 3 or 4). Altogether 4 cameras can be
taught in.
• Once you have selected the corresponding channel, press the "channel selection
switch" (18) to start the connection search. You now have 60 seconds to press
the corresponding pairing button on your radio camera.
• Press and hold the button "Pairing" (9) on your radio camera for approx. 5 sec-
onds.
• If the connection was established successfully, the corresponding camera image is
displayed on the desired channel and the "LED Link" (2) on the camera is lit.

7.3 Signal strength

An aerial icon is displayed on the top of the screen. Vertical lines are displayed next
to the aerial icon to indicate the signal strength (max. 4 lines = best reception).
25