Adjusting The Volume; Reset To Factory Settings (Reset); Troubleshooting - Conrad Electronic 75 15 09 Operating Instructions Manual

• With the buttons "Left" (16) or "Right" (20), select the desired switching time (in
seconds) or the option "OFF" to deactivate automatic switching.
• To apply the settings, press the "Menu" (15) button.

7.6 Adjusting the volume

You can set the volume of the integrated microphone. Proceed as follows:
• Press the "MENU" button (15). This takes you to the setup menu.
• With the buttons "Up" (14) and "Down" (17), select the menu item "Audio vol".
• With the buttons "Left" (16) or "Right" (20", set the desired volume.
• To apply the settings, press the "Menu" (15) button.

7.7 Reset to factory settings (RESET)

To perform a RESET, proceed as follows:
• Press the "MENU" button (15). This takes you to the setup menu.
• With the buttons "Up" (14) and "Down" (17), select the menu item "Reset".
• Press the "Channel selection" button (18) to restore the factory settings.

8.Troubleshooting

Problem
Display
"NO Connection" radio camera.
Possible cause
No power supply for the
No connection check
performed so far.
The camera is out of range.
Recommendations
Access the respective camera
to check the power supply.
If the camera receives volt-
age, the "Power LED" (3) is
lit.
Please refer to chapter 6.2.
"Connection search"
Place the camera closer to
the receiver.
27